Welcome To Bai Young (ShanDong) Metal Manufacturing (Group) Co., Ltd.
WhatsApp ：+8613276356535 Email : info@baiyoungchina.com
-
PRODUCT CENTERThe group has 15 production lines including pickling line, cold rolling line, hot dip (thickening) galvanizing line, hot dip galvanizing line and color coating line.
Introduction of stainless steel plate
The stainless steel plate has a smooth surface, high plasticity, toughness and mechanical strength, and is resistant to corrosion by acids, alkaline gases, solutions and other media. It is an alloy steel that is not easy to rust, but it is not absolutely rust-free.
16
2022
/
09
What is the difference between carbon steel and stainless steel
The density of carbon steel is slightly higher than that of ferritic and martensitic stainless steel, but it is lower for austenitic stainless steel, so the difference between carbon steel and stainless steel is different.
16
2022
/
09
Advantages of stainless steel material
Aesthetically pleasing surfaces and diverse possibilities of use;
Good corrosion resistance, durable than ordinary steel;
18
2023
/
04
What are the classifications of corrugated board?
(1) Classified according to the application site - divided into roof panels, wall panels, floor decks and ceiling panels, etc. In use, colored steel plates are used as wall decoration panels at the same time, and the architectural decoration effect is relatively novel and unique.
16
2022
/
09
Difference Between Stainless Steel and Carbon Steel Compare the Difference Between Similar Terms
Stainless steel is the abbreviation of stainless acid-resistant steel. It is very resistant to weak corrosive media such as air, steam, and water. Carbon alloy, also known as carbon steel, contains small amounts of silicon, manganese, sulfur, and phosphorus.
24
2023
/
03
Advantages of color coated steel plate
I-shaped beams are hollow web members. For high-strength materials, hollow web members are better than solid web members in terms of weight, material, and labor saving. This cross-sectional design mainly uses the flange farthest from the centroid to resist bending moments (because the farther the flange is, the greater the moment of inertia), and mainly uses the web to resist shear. As for the inconvenience in making it, it can be solved by factory or molding. Saving materials, labor, and time is efficiency.
14
2023
/
03